Standard pole mount consist of mounting the gateway to a pole using the two provided cable ties.

The following install guide has been made for the LORIX One and stays valid for the Wifx L1.

Instructions

Remove the wire grommet from the cap.

Once the Ethernet cable passed through the cap hole, open the silicon grommet and put it around the cable as showed on the picture.

Be careful with the orientation of the grommet

Press the grommet with your finger from inside the cap (first picture) until take it final position (second picture).

Connect the Ethernet cable.

Move the cap in direction of the body while maintaining the cable with the other hand to keep the cable as straight as possible.

Screw the cap on the body to guarantee as good as possible water and dust protection.


Once fixed, be sure the cable is well placed and verify that the grommet is correctly positioned.

Use only appropriate antenna provided as accessory for the LORIX One/Wifx L1.

Engage the antenna connector into the gateway RF connector as shown on the picture.


While maintaining the antenna into the gateway, start screwing with the other hand the gateway RF connector tightening ring.

Never turn or use directly the antenna body to screw it on the gateway, it could damage or break the antenna.

Once the cable and the antenna correctly connected and the gateway correctly closed, you can install it on a pole using the 2 provided cable tie.

The provided cable ties are black because they are specifically made to support UV.

You should use always the provided ties or UV protected specifically.