Using the accessory WHR-L01-W02, you can mount the gateway on a wall in outdoor conditions.

Instructions

The WHR-L01-W02 is intended to be mounted on the wall first, then the LORIX One to be mounted on it.


Following that, the first step is to drill one of the two holes, put the plastic wall plug and screw the first screw using the torx T20 screwdriver. Do not forget to add the flat washer between the head screw and the surface of support.


Once the first screw in place, mark the position of the second hole and repeat the operation for the second screw. The final result is shown as follow.

Vertical alignment

Thanks to the oblique holes of the support, you can easily adjust the vertical orientation of the support.

You can now screw the two screws using a torx T10 screwdriver as showed (compatible model including the nut inserts)

Final control

As with any installation, be sure to properly manage the installation of the Ethernet cable to ensure that the entire system is waterproof.

A common method is to create a loop of cable under the Wifx L1 and secure it properly to the mast to ensure that any water stagnation remains below the cable grommet and that there is no mechanical stress on it.