Using the accessory WHR-L01-W01, you can mount the gateway on a wall in indoor condition. 

Instructions

The WHR-L01-W01 is intended to be fixed on the Wifx L1 before any installation on the wall.


The first step is to install the support on the back of the Wifx L1.

Use a torx T10 screwdriver to screw the two flat head screws at the back of the Wifx L1.


Be careful to fix correctly the two screws ensuring the support is not moving. Strength of screwing should be correctly adapted to avoid on the contrary any pull-out of the metal inserts from the plastic body.

The WHR-L01-W01 has space for the screw on one side, make sure that the screws are in place when fully tightened and that the head surface matches the support's surface as shown in the picture.

The mounting of the bracket in the wall is done in two steps. You first need to drill the first (upper) hole, put the plastic wall plug and screw the first 4x30 wood doom head screw using torx T20 screwdriver.


You must keep space for the support thickness. The support must fit as showed below (without any product fixed on it for a better illustration).

Once this first screw in place, it's time to mark the place of the second hole in the wall

With the Wifx L1 fixed on the support

Once the second hole completed, you can place the plastic wall plug and screw the second screw as showed.

Final control

As this installation is meant to be kept indoors, there is no special aspect to be taken care of. However, it is important to avoid overloading the cable gland and the internal Ethernet connector by securing the cable correctly.